When designing your system, Speck& Burke apply computer modeling and extensive expertise to produce customised, efficient systems.

Before designing a system we discuss your current and future requirements. In this way we develop a thorough understanding of your instrumental requirements for flow, pressure and purity. The Speck & Burke experts then apply the latest codes of practice and extensive experience to develop a solution that meets your performance needs, budgetary constraints and future requirements.

Some of the key benefits you will realise from a Speck & Burke designed system are:

  • Fewer fittings for reduced cost.
  • Correctly sized tubing to achieve maximum purity,saving gas and time.
  • Design that complies with the Codes of Practice of the British Compressed Gas Association.


Some of the key benefits you get from and Speck & Burke installed system are:

Purity & Cleanliness
All our tubing is chemically clean to ensure that no contamination is introduced into your instrumentation. High quality compression fittings are used so there are none of the purity problems which can be caused by brazing flux.

High Quality Finish
We take every precaution to hide tubing completely whenever we can and trunk it when that is not possible.

Fully Operating System
We terminate our lines with fittings to suit the instruments you intend to use so you can resume work immediately.

System Reliability & Efficiency
We always leak test and certify our systems prior to departure, leaving you with a permanent record on which to base future inspections.
 
Installations are carried out using expertise gained over many and varied systems to install fully tested and functioning systems on time at a competitive price. Our installations are carried out by experienced engineers with knowledge of laboratory instruments as well as
gas systems.

Design & Installation Enquiry